ARCHSPLACE
Architecture, made simple — since 2018
Beam

PlanBin the studio

Beam

Beam draws a beam between two clicks, with the section chosen beside the tools, spanning under the ceiling of the level. Its ends join other beams' ends the way walls join, and its size is then set in its panel.

What it is

Beam draws a straight beam from one point to another. The list beside the tools offers four sections, width by depth: 15 by 40, 20 by 50, 25 by 60 and 30 by 70 centimeters. The beam spans under the ceiling of the level it is drawn on.

A beam is a run, like a wall or a pipe: an end you put on another beam's end joins it, selected beams show grips where they meet, and a joint moves with every beam meeting there.

When to use it

  • Spanning between columns of a structural grid.
  • Carrying a floor over an opening or a large room.
  • Redrawing the beams of a surveyed building.

The steps

  1. Take the tool. Press B, or click the Beam button. The status bar says to click the start and the end.

    Beam armed with Structural ticked under Disciplines: the beam button is lit among the drawing tools, its name Beam (B) is under the hand, the section list reads 15 x 40, and the status bar says to click the start and the end, the beam spanning under the ceiling.
  2. Choose the section. Pick it in the list beside the tools.

    The section list set to 20 x 50 centimeters, with the hand on the arrow of the list beside the tools: the Structural overlay draws the footings of the walls as dashed outlines on the plan.
  3. Click the start. The magnet holds the click on a column's center, a wall's corner, a grid crossing or another point within reach.

    The hand on the middle of the bottom wall: a triangle marks the point the magnet holds, and the status bar names it a midpoint, the start the next click will take.
  4. Click the end, or type the length. Click where the beam ends, or type its length in the project's units and press Enter to end it that far toward the cursor. Shift, or F8 while it is on, keeps it horizontal or vertical. Each beam takes two new clicks; the next one does not start where the last ended.

    The hand aimed north from the start with 13 typed: a dashed beam rises from the wall toward the hand, and 13 with an Enter mark is written beside it in place of the length.
  5. Adjust it in its panel. Select the beam with Select to type its width, its depth or its length.

    The beam taken with Select: BM-001 is lit in the outliner, a dashed beam crosses the living room from the bottom wall to the top one with a grip at each end, and its panel lists its length, 13'-0", its width and its depth.

What it refuses

  • A beam under 10 cm. The project refuses a beam shorter than 10 cm: the status bar counts one more error, and its list says the beam has no length.
  • A second click on the start. A click within the magnet's reach of the start does nothing.

What it writes to the contract

One new entry at the end of the project's list of beams, as one step that one undo takes back: the level, its two ends in meters, its width and its depth, and the phase the view draws in. An end that joined another beam's end is written at exactly that end.

Concepts

Common questions

Where does a beam stand in height?

Under the ceiling of the level it is drawn on. It shows on the plans with the Structural overlay and on the ceiling plan, as a beam overhead.

Do beams chain like walls?

No. Each beam is its own two clicks. An end put on another beam's end joins it, so the two meet in one point.